Signode AK200HDX-19, Руководство по эксплуатации, частям и безопасности

Страница: 30 / 82

16
6.8 To remove cams from camshaft display
(see drwg. 464613, page 33)
- Remove release pin (see drwg. 464631, pos. 58, page 33).and swing back strap guide
wedge with strap guide chain (see drwg. 464631, pos. 10, page 33). Also swing out the
stop device.
- Remove the spring retainer (see drwg. 464655, pos. 5, page 39) and the 2 pcs. pressure
springs with guide pins.
- Open shutter . (see drwg. 464655, pos. 1, page 39)
- Remove pressure pad for shutter, (see drwg. 464655, pos. 13, page 39)
- Push gripper forward using a C-clamp to take the load off the cam levers.
- Turn back adjustment screws from levers. Adjustment screws should not put any
pressure on the cross bars of grippers (see drwg. 464631, pos. 94, page 33).
- Rotate camshaft into position 7.
- Remove socket head cap screws from camshaft flange.
- Use long socket head cap screws and insert them into thread of camshaft flange, pull off
camshaft flange.
Note: Take care that the cams have no contact with the levers and the proximity switches.
- Remove camshaft.
- Remove countersunk screw and disc (see drwg. 464613, pos. 7 and 17, page 33) and
remove bevel gear and ball bearing.
- Remove the cams and exchange cams if necessary.
6.9 To remove belleville washers from spring assembly
(see drwg. 100.007, pos. 11, page 58)
- Remove release pin (see drwg. 464631, pos.58, page 33) and swing back strap guide
wedge with strap guide chain (see drwg. 464631, pos. 10, page 33). Also swing out the
stop device.
- Remove sleeve (see drwg. no. 100.007,pos. 2, page 58) from guide shaft (see drwg.
100.007,pos. 1, page 58).
- Remove adjustment nut (see drwg. no. 100.007, pos. 4, page 58).
- Exchange belleville washers.