Signode AK200HDX-19, Руководство по эксплуатации, частям и безопасности

Страница: 29 / 82

15
6.4 To remove gripper "tip of strap"
(see drwg. 464655, pos. 8, page 39)
- Dismantle gripper as described under point 6.2 and 6.3.
- Note, remove first vibrator incl. vibrator support before dismantling the gripper.
6.5 To remove clutch Y37 from transmission
(see drwg. 100.36, pos. 41, page 43)
- Remove 2 pcs. socket head cap screw and take off belt guard
(see drwg. 464631, pos. 55 - 57, page 33).
- Remove countersunk screw and washer (see drwg. 100.36, pos. 46, 20, page 43).
- Pull off magnet part of clutch.
- Remove socket head cap screws (see drwg. 100.46, pos. 33, page 43) and slide off the
armature of the shaft (see drwg. 100.36, pos.50, page 39).
- Install new clutch.
ATTENTION:
When installing the clutch make sure that the armature and the rotor are free of grease or oil
and that the gap between them is 0.2 mm (The gap can be set by using a calibrated disc), (see
drwg. 100.36, pos. 42, page 43).
6.6 To remove the transmission
(see drwg. 464631, pos. 8, page 33)
- Remove pulley guards (see drwg. 464631, pos. 39, 55, page 33).
- Loose socket head cap screw (see drwg. 464631, pos. 19, page 33) to slacken toothed
V-belt (see drwg. 464631, pos. 61, page 33)
- Remove timing belt.
- Remove socket head cap screw (see drwg. 100.36, pos. 63, page 43) and take off the
transmission. In order to reduce down time, we recommend the purchase of a
transmission for quick exchange.
6.7 To remove the feedwheel ring
(see drwg. 464626, pos. 6, page 47)
- Remove release pin (see drwg. 464631, pos. 58, page 33) and swing back strap guide
wedge (see drwg. 464631, pos. 10, page 33) with strap guide chain.
- Remove weld motor (see drwg. 464631, pos. 83, page 33).
- Remove lower fitting bolt of seal mechanism (see drwg. 464655, pos. 55, page 39).
By removing the weld motor, the hexagonal nut of the fitting bolt is easily accessible.
- Swing guide wedge (see drwg. 464655, pos. 60, page 47) forward.
- Remove 6 pcs. socket head cap screws (see drwg. 464626, pos. 34, page 47).
- Insert 2 pcs. socket head cap screws into plan gear cover (see drwg. 464626, pos. 3,
page 47) to pull off cover.
- Take off feed wheel ring.