SIGNAMAX a.s.
Office: Vlarska 22, 627 00 Brno, CZ
T:+420 533 338 854 l F:+420 533 338 883 l www.signamax.eu
117
Svid: Specify “Svid” to replace an original service provider VID with a new one for
egress traffic. When this is used, you need to set up the new service provider VID in
“New Service VID” field below.
Cvid: Specify “cvid” to replace an original customer VID with a new one for egress
traffic. When this is used, you need to enable “Replace Customer VID” and set up
“New Customer VID” field.
Action: Configure which action is taken when you choose “Forward” permit type.
Permit: Select “permit” to allow all packets to pass through.
Drop: Select “drop” to discard the packets.
Redirect: Select “redirect” to route packets to the specific port. If you want to use
“Redirect”, you need to set up a redirect port.
Copy to CPU: Select “Copy to CPU” to send a copy of packets to CPU.
Redirect Port: Select a redirect port.
Logging: Specify a logging ID that applies to this ACL rule.
Rate Limit: Specify the rate limiting ID that applies to this ACL rule.
New Service VID: Specify a new service provider VID between 1 and 4094.
Replace Customer VID: Enable or disable Customer VID function.
New Customer VID: Specify a customer VID between 1 and 4094 to replace old one in
egress traffic.
Reassign Queue: Select “Enable” to replace an old queue with a new priority queue.
New Queue: Specify a new customer priority queue (0~7) to replace an old one for egress
traffic. The priority queue setting can be changed in DSCP Remark.