SIG Rascal 80 eg, Инструкция по сборке

Страница: 9 / 23

9
b) Finish the rudder installation by gluing the CA Hinges in place
with thin CA.
❑
17) Look closely and you will find three holes pre-drilled near the
bottom of the rudder for mounting the nylon control horns. Run
a 5/64” Drill through the three holes. Install the Pull-Pull control
horns on the both sides of the rudder, using three M2 x 14mm
Screws and three M2 Nuts, making sure to add a drop of thread
locker to each screw before tightening the nut.
❑
18) There are three holes pre-drilled in the RIGHT side elevator for
mounting a nylon control horn. Screw the control horn in
position on the bottom of the elevator, with the retaining plate
on the top, using three M2 x 14mm Screws and three M2 nuts,
making sure to add a drop of thread locker to each screw before
tightening the nut.
❑
19) Next we will mount the Tailwheel Assembly in place on the lower
rear end of the fuselage.
a) Begin by placing the three armed rudder steering horn on the
bottom of the rudder. The front edge of the steering horn should
be 1 / 4” back from the beveled edge of the rudder. Mark the
location of the two steering arm holes on the bottom edge of the
rudder.
b) Using a 5/64” drill bit, drill a hole at each location you marked,
Making sure to keep the drill bit straight to the rudder - you
do not want the drill bit to come out the side of the rudder.
c) Thread one of the M3.5 PWA screws into each of the holes, then
remove the screw. Add a drop of thin CA to each hole to harden
the threads. When the CA has dried, install the three armed
steering horn to the bottom of the rudder with the two M3.5
screws.
d) Attach the pre-assembled tailwheel bracket to the fuselage using
two M3x18mm machine screws and split-ring lock washers. Add
a drop of thread locker to each of the M3x16mm machine screws
before tightening them.