9
Figure 12
Figure 13
HI TEMP/FLUE AND TRIM INDICATORS:
W hen the H i-Tem p/Flue indicator light com es o n (red lite
beneath control button) it means that the flue is obstructed
or you have a re verse draft and gases cannot ex it properly.
Maintenance is required and a thorough cleaning and pipe
check m ust be performed.
TRIM button :
Underneath the control button you will find a
sm all ro und butto n that w ill turn fo rward and rev erse. This
button can control the fee d m oto r in th e LOW positio n only.
By turning the button clockwise you can increase the feed
on LOW and by turning it counterclockwise you can
decrease the feed in the LOW position.
M ove this button carefully!
It is designed to fine tune
your LOW setting in the event you ch ang e bra nds of pe llets
and/or live at a higher elevation.
DC OPERATION - BUILDING A FIRE AND
START-UP
IMPO RTANT (Gold Units O nly):
Gold is a soft metal and
therefore a fragile surfa ce. Prior to th e first b urn it is important
to use W index™ or co m para ble produ ct with a soft clean cloth
to wipe any marks off all gold surfaces.
If not cleaned prior to first burn, the heat may cause the marks
to rem ain in the surface perm anently.
Always clean the gold surface when the heater is COOL.
1. Filling the Hopper and Start-Up:
CAUTION:
Fuel hopper lid m ust be closed be fore
operating unit. Maintain hopper seal in good condition.
DO NOT OVERFILL HOPPER!
The
EAS YF IRE will hold
about 35 lbs. to 50 lbs. of pellets depending on hopp er
heigh t.
Open the top lid and fill the hopper with pellets (
Figure 9
).
The quality of pellet fuel varies from bra nd to brand. This
will affect the efficiency of your heater. W e suggest that you
try several brands until you find one that gives you a clean effi-
cient burn. Poor quality pellets will burn rich with black soot
and ash will accu m ulate quickly. Quality pellets will burn clean
and ash build up will be m inim al.
Mak e sure hop per lid is fully closed. Ope n the front door.
Fill th e F ire Pot with pellet fuel.
IMPORTANT:
The Fire Pot must be seated flush and
must sit even in the pot tray. Air leaking around the Fire Pot
will create a poor burn (
Figure 10)
. Light the pellets in Fire
Pot using any approved lighter fluid.
Allo w pellets to burn for approxim ate ly 1 m inute, o r un til
pellet ignition has be en a chieved.
Close door
and turn the
control knob to the
"FAN"
position. Allow fire to burn for
several minutes. W hen the pellets are well lit, turn the
control knob to
"L OW "
for approximately 10 minutes then
turn up to
"HI"
. W e recomm end that you run the heater on
“Medium” or "HI" for about 30 minutes in order to get the
heat exc hanger hot before turning it to "LO W ". Yo u will
need to burn the heater for a few hours before deciding
which setting is best for your particular needs.
All manuals and user guides at all-guides.com
