Listed by OMNI-Test
Laboratories, Inc.
Report No. 256-S-01-4
Sierra Products, Inc.
5061 Brooks St., Ste B
Montclair, CA 91763
(909) 399-3355
INSTALLER: PLEASE LEAVE THIS MANUAL WITH THE OWNER!!
NOTE: This heater should not be installed in a
bedroom or bathroom.
SAFETY NOTICE
<
CAUTION: HOT WHILE IN OPERATION. KEEP CHILDREN,
CLOTHING AND FURNITURE AWAY. CONTACT MAY
CAUSE SKIN BURNS.
<
IF THIS HEATER IS NOT PROPERLY INSTALLED,
A HOUSE FIRE MAY RESULT.
<
CONTACT LOCAL BUILDING OFFICIALS ABOUT RE-
STRICTIONS AND INSTALLATION INSPECTION REQUIRE-
MENTS IN YOUR AREA.
<
FAILURE TO COMPLY WITH OWNERS' MANUAL IN-
STRUCTIONS WILL VOID YOUR WARRANTY!
Please read this entire manual before installation. Save these instructions.
EF4001B AutoLite Pellet Stove Insert
Installation & Operating Instructions
PLEASE READ THIS ENTIRE MANUAL BEFORE INSTALLATION
AND USE OF THIS PELLET FUEL-BURNING ROOM HEATER.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN
PROPERTY DAMAGE, BODILY INJURY OR EVEN DEATH.
GENERAL INFORMATION
Installation and repair should be done by a qualified
service person. The heater should be inspected before use
and at least annually by a professiona l service person. More
fre quent cleaning m ay be re quired due to fuel quality,
excess ive lint from carpetin g, bedding m ate rial, etc . It is
impera tive that control com partm ents , burn pot and c irculat-
ing air passageways of the heater be kept clean.
The EASYFIRE Pellet Insert has been designed and
approved for burning
w oo d p ellet fu el on ly
. Bu rning solid
fuel in other forms is not permitted and will void all warran-
ties.
This unit has been approved for use with a
Ø 3" Type L
Pellet Vent System or Stainless Chimney Liner
(Ø 4" on
runs 10 fee t and above).
NEVER use gasoline, gasoline-type lantern fuels,
kerosene, charcoal lighter fluid, or similar liquids to start or
"freshen up" a fire. Keep all such liquids well away from the
heater while it is in use.
Ashes must be disposed of in a metal container with a
tight fitting lid and placed on a noncombustible floor or
ground, we ll away from all fu els, pending fina l disposal.
NOTE :
During the first few burns the high tem perature
paint and sealant used in manufacture will emit some odor
and smoke. Open doors and windows to the outside for
proper ventilation during the first burn cycle and curing of
the paint.
This heate r, when insta lled, m ust be electrically gro unded in
accordance with local codes or, in the absence of local
codes, with the
National Electrical Code, ANSI/NFPA 70-
2006
.
All manuals and user guides at all-guides.com
all-guides.com
