en
Faults and what to do about them
50
Caution!
Water damage!
Any escaping water may cause water
damage.
Do not open the door if water can be
seen through the glass.
1.
Switch off the appliance. Pull out the
mains plug.
2.
Drain the water
~
Page 48
3.
Pull the emergency release
downwards with a tool and release.
The door can then be opened.
Information on the Touch-Display
Display
Cause/Remedy
Œ
■
Flashes fast + signal
: The door was opened and the water level is too high.
Close the door, continue the programme with
I
button or select
0
Spin
.
■
Flashes slowly
: The door lock temperature is too high to open the door. Wait
approx. 30 seconds until the door lock temperature cools down.
|
■
Flashes
(no water supply): Tap turned on? Filter in the water supply is
blocked?
~
"Filter in the water supply is blocked" on page 49
Is the supply hose kinked or trapped?
■
Lights up
(low water pressure): For information only. This will not affect the
programme progress. The programme duration is extended.
Ó
lights up
The detergent drawer has not been pushed in completely. Push the detergent
drawer in correctly.
E:3610
E:36
alternating display with
-10
and
End
when programme is finished:
■
The drain pump is blocked.
~
"Drain pump is blocked" on page 48
■
The drain hose at the siphon is blocked.
~
"The drain hose at the siphon is blocked" on page 49
E:3510 (Suitable for
special models)
E:35
alternating display with
-10
and
End
when programme is finished: there is
water in the base trough, the appliance is leaking. Turn off the tap. Call customer
services.
w
lights up
The childproof lock is activated – deactivate it.
f
lights up
Too much foam has been detected and an additional rinse cycle has been activated.
Reduce the basic dosage of
ß
i-Dos for the next washing cycle with the same load.
