39/46
Siemens
Heating controllers RVP201 and RVP211
CE1P2464en
Building Technologies
6 Mechanical design
2017-07-21
6 Mechanical
design
6.1 Controller
6.1.1 Basic
design
The RVP201/211 is comprised of controller insert, which houses the electronics, the
power section, the output relays and all operating elements (on the controller front), and
the base, which carries the connection terminals. The operating elements are located
behind a transparent cover. At the rear of the cover, there is a slot where the operating
instructions can be inserted. The cover can be sealed.
The time switch is of plug-in design. The coding switches and setting potentiometers for
the plant-specific settings can be accessed after removal of the time switch.
If the controller is used without a time switch (RVP201.0 or RVP211.0), the space for
the time switch is covered up with a hinged cover. If a time switch is fitted at a later
time, the appropriate hole in the cover must be cut out with a knife.
The RVP201/211 can be fitted in three different ways:
Wall mounting
Rail mounting
Flush panel mounting; in that case, the front panel may have a maximum thickness
of 3 mm
To make certain the controller will be mounted the correct way, both base and casing of
the controller insert are marked "TOP".
First, the base is fitted and wired up. Then, the controller insert is secured to the base
by means of two screws. The fixing screw at the top can be sealed: screw the plug (to
be ordered as a separate item) into the threaded hole, insert a sealing wire through the
two lugs and seal it.
6.1.2 Dimensions
16,4
26 26 26 26
1
4.
3
9
6
144
114,7
19,7
6
0,
4
14
56
112
4
,5
138
+1
0
9
2
+
0,
8
0
2
4
64
M
01
144
max. 3
IEC 61554 - 144 × 96
3
5
±0
.3
EN 60715
max. 5
M
16
EN 50262
2
2
max. 8
Dimensions in mm
