Siemens POL955, Инструкция по установке, использованию и техническому обслуживанию

Страница: 81 / 96

81
TUTORBIT
COSMOGAS
Continued on the next page
6 - USE
Adjustment
Factory
Start hyst
Switch-on dif
ferential of the heat generators with respect to the DHW setpoint
Factory
0...20
3 K
Stop hyst
Switch-of
f dif
ferential of the heat generators with respect to the DHW setpoint
Factory
0...20
3 K
Light-on delay
Heat generators switch-on delay time
Factory
0...900
1 s
Light-of
f delay
Heat generator switch-of
f delay time
Factory
0...900
1 s
Temp of
fset up
Increase of the heat generators setpoint with respect to the DHW setpoint
Factory
0...20
10 K
Post pumping
DHW pump post-circulation
Factory
0...900
60 s
DHW return setp
DHW recirculation circuit setpoint (enabled only if Configuration>System>DHW return sensor =
Yes)
User
0...100
50 °C
DHW return timer prog.
DHW return timer program
Installer
Reset
Delete time programme
Installer
No...Y
es
No
Copy
Copy time programme command
Installer
No...Y
es
No
From:
Selection of the first day to start copying
Installer
Monday
...
Sunday
Monday
To
:
Selection of the last day to end copying
Installer
Monday
...
Sunday
Monday
Monday Start Stop 06:00 8:00 12:00 14:00 18:00 22:00
Setting the 3 operating time slots on Monday
, T
uesday
, W
ednesay
,Thursday and Friday
.
Installer
Time program
Installer
Saturday
S
ta
rt S
to
p
06:00 8:00 12:00 14:00 18:00 22:00
Setting the 3 operating time slots on Saturday
.
Installer
Sunday
Setting the 3 operating time slots on Sunday
.
Installer
Antifreeze setpoint
Antifreeze setpoint that is enabled when “Parameters>System control =
Antifreeze”
User
5...90
10 °C
Zones
Heating circuits operating parameters
User
Zone1
Heating circuit 1
User
Operative mode
Room sensor operating mode.
Auto = room temperature adjustment according to the time program set on
the controller; Comfort = room temperature regulation; Precomfort = room temperature regulation; Reduced = fixed temperature room regulation; Protection = setting of the frost protection environment. (Appears only when room sensor QMX3 is combined with Zone 1)
User
Auto-Comfort- Precomfort- Reduced-Of
f
Comfort
Action
Manual = manual setpoint adjustment;
Automatic = adjustment according to the weekly program; Of
f = service
off.
This parameter it is not visible if Configuration>Zones>Zone mode 1 = Outd Reset-RS/ FixSp-RS.
User
Manual; Automatic; Of
f
Manual
Heat Supply Setp
Manually adjusted fixed setpoint.V
isible only if Configuration>Zones>Zone mode 1=FixSp-R
T/ FxSp-Comp.R
T
User
20...90
60 °C
Night setback
Reduction of the supply temperature generated by theR
T opening. V
isible only if Configuration>Zones>Zone
mode 1 = Outd Reset comp-R
T/FxSp-Comp.R
T
Installer
0...20
10 K
Antifreeze setpoint
Antifreeze setpoint at which the circuit is set when “Parameters>System control =
Antifreeze”
Installer
20...90
30 °C