Siemens i-3, Руководство пользователя

Страница: 12 / 80

10
The diagram below illustrates the position of these input terminals in
i-3 V2 controller I/O board.
Figure 4-2
Input Terminals in the Input Wiring Section
Common input types
Table 4-1
lists the typical input types supported by i-3 Control Technology V2 system.
Chapter 4
Control Inputs/Outputs
Table 4-1
Common Input Types
Input Type Description Comments
0 Digital input maintain toggle switch (2-wire) If the value changes, then invert the state
1 Digital input maintain toggle switch (2-wire) – blinking if the value changes, then invert the state
2 Digital input maintain normally on switch (2-wire)
3 Digital input maintain normally on switch (2-wire) – blinking
4 Digital input maintain normally off switch (2-wire)
5 Digital input maintain normally off switch (2-wire) – blinking
6 Digital input momentary toggle switch (2-wire)
7 Digital input momentary toggle switch (2-wire) – blinking
8 Digital input momentary normally on switch (2-wire)
9 Digital input momentary normally off switch (2-wire)
10 Digital input dual-momentary switch (3-wire)
11 Digital input dual-momentary switch (3-wire) – blinking
Analog outputs
Analog inputs
Digital inputs
Digital inputs
common
24 VDC
Digital inputs
TB5
TB6
TB1
TB3
TB4
TB2