Siemens HB36D.75., Инструкция по эксплуатации

Страница: 24 / 36

24
Attaching the rail
1.
Position the rail so that the indentations are facing upwards.
2.
Hook the rail in at the back and push it towards the rear until
it engages (fig. C).
3.
Hook the front of the rail onto the holder and press down until
it engages and is fixed level in place in the appliance once
more (fig. D).
Each set of rails only fits on one side.
Troubleshooting
Malfunctions often have simple explanations. Please read the
following instructions before calling the after-sales service.
Repairs may only be carried out by fully trained after-sales
service technicians. Incorrect repairs to your appliance may
present considerable risks for the user.
:
Risk of electric shock!
■
Work on the appliance electronics may only be performed by
a specialist.
■
Always disconnect the appliance from the power supply
when work is carried out on the electronics. Switch off the
circuit breaker or remove the fuse from your household fuse
box.
' &
Problem Possible cause Notes/remedy
The appliance does not work The plug is not plugged into the mains. Connect the appliance to the electricity
supply
Power cut Check whether other kitchen appliances
are working
Fuse defective Check in the fuse box to make sure that
the fuse for the appliance is OK
Faulty operation Switch the appliance off using the fuse in
the fuse box. Wait approximately 10 sec-
onds and then switch it back on.
The appliance cannot be started The appliance door is not fully closed Close the appliance door.
The appliance cannot be started, the dis-
play shows
"Continue operation with 'Start'"
"Descale"
Descaling has been cancelled Press the Start button. Then rinse the
appliance twice (see section: Descaling.
Proceed as described under "Emptying
the evaporator dish and refilling the water
tank")
The appliance cannot be started, the dis-
play shows
"Continue operation with 'Start'"
"Clean"
The cleaning aid has been cancelled Press the Start button. Then rinse the
appliance twice (see section: Cleaning aid.
Proceed as described under "Emptying
the evaporator dish and wiping out the
appliance")
"Clock" appears in the display Power cut Reset the clock
(see section: Time-setting options)
The appliance is not in operation. A cook-
ing time is shown in the display.
The rotary selector was accidentally oper-
ated
Press the Stop button
The Start button was not pressed after the
setting had been made.
Press the Start button or delete the setting
with the Stop button
"Automatic switch-off" appears in the dis-
play
The Automatic switch-off is active. Press any button.
"Fill water tank" appears even though the
water tank is full
The water tank has not been pushed in
properly
Slide in the water tank until it engages
The detection system is not working Call the after-sales service
"Fill water tank" appears even though the
water tank is not yet empty, or "Fill water
tank" does not appear even though the
water tank is empty
The water tank is dirty. The mobile water
level indicators are jammed
Shake and clean the water tank. If the
parts cannot be released, obtain a new
water tank from the after-sales service.
The water tank empties for no discernible
reason. The evaporator dish is overflowing
The water tank was not closed properly Close the lid until you feel it engage.
The tank lid seal is dirty Clean the seal
The seal in the tank cover is defective Obtain a new water tank from the after-
sales service