Instructions for fitting connectors, attachments and devices
2.3 Electrical networks
Passive network components
22
System Manual, 02/2013, C79000-G8976-C282-01
Procedure
1.
In the stripping tool, use the green
knife cassette (5.1 mm).
If necessary, adjust the cutting dept
knife cassette using the middle
ket-head screw.
h of
the
soc
2.
Take the stripping tool in your right
hand.
3.
Measure the cable length against
the measuring template. Use your
left index finger as the limit stop.
Note: If the stripping tool has an older
measuring template, add the new
measure (38 mm from the edge of the
stripping tool).
4.
Place the cable in the stripping tool.
The index finger of your left hand is
the limit stop.
5.
Tighten the stripping tool.
6.
To strip the insulation, turn the tool
in the direction of the arrow
–
approx. 4 times for PVC
insulation
–
approx. 8 times for PUR
insulation
7.
Keeping the it closed, pull the
stripping tool with jacket and
remnants of the shield off the end of
the cable.
Note: If a core is damaged, the section
of cable must be cut off and stripped
again.
8.
Remove any remaining white filler
with your fingers.
9.
Cut off the inner cable spacer as
close to the shield braid as
possible. Also shorten the cable
spacer between the two pairs
orange/orange-white, green/green-
white, and blue/blue-white,
brown/brown-white.