Router User’s Guide
Configuring Network Settings
RIP (Routing Information Protocol)
By default, the SpeedStream Router does not support routing protocols. However, support for the Routing
Information Protocol (RIP), versions 1, 2 or 1 and 2, can be activated. This support may be configured for
any WAN connection currently configured or for the LAN in general.
Using RIP, the Router is able to determine the shortest distance between two points on the network
based on the addresses of the originating devices. RIP is based on distance algorithms to calculate the
shortest path using information in the routing table. The shortest path is based on the number of hops
between two points.
To use the RIP option:
1. Select
Setup>RIP
from the left navigation pane of the Web interface. This displays the “RIP
Configuration” window.
2. Select one of the following options from under the
RIP Version
heading next to the connection of
your choice:
•
1
: Provides essential RIP packet formatting for routing information packets.
•
2
: Provides enhanced packet formatting for routing information packets by providing the following:
IP address, subnet mask, next hop, and metric (shows how many routers the routing packet
crossed to its destination.
•
1&2
: A combination of both types of RIP packets.
3. Select
an
Active Mod
e checkbox next to a corresponding connection to enable it.
4. Click
Apply
. This displays the “Your Settings Have Been Saved” window.
5. Optionally,
click
Reboot
if you wish for the settings to immediately be implemented. The system
responds by restarting your Router.
32