Siel SAFEPOWER SPM, Инструкция по установке и эксплуатации

Страница: 20 / 65

IV374E Rev.03 Installation and user manual
Date of issue : 2016-09-06 Page 18 of 63 + FR
3.10 Online UPS modules Replacement
For the UPS, modules must be inserted to make a complete UPS system.
The replacement of UPS module is very simple and can be operated online.The control
system of the UPS can detect the inserted or removed module(s) automatically. The user may
operate easily by following the steps mentioned below.
◆
NOTE: The UPS module is rather heavy, please move it by two people!
◆
Insert module
(1) Remove decorated panel;
(2) Put the UPS module in the cabinet module slot. Push the module along the slot into the
cabinet until the module is inserted properly.
(3) Fix the module with screws (M5) at the positioning screw holes;
(4) Switch on the bypass switch,mains switch and output switch accordingly.
(5) After the modules start up , the system will detect the modules inserted automatically,
and parallel up the modules into whole system.
◆
Remove UPS module
Remove the coronal screws on the left side of the module to stop the module running
completely and remove the module after fan stop spinning.
WARNING!
(1) Make sure the LCD screen is totally off before removing the module; otherwise, electric sparks will
occur at the connection of module and system cabinet.
(2) The coronal screw at left side or rignt side of the module controls the operation of the module.
Only after the screw is tightened, the module can start running. When insert new module, make sure
the screw is tightened properly.
(3) When insert the module under battery mode, please press
“ON” button at module’s LCD panel