Sidekick SK-8RG, Руководство пользователя

Страница: 4 / 20

4
SETTING UP THE UNIT Cont.
There are five drain outlets in the back of the unit:
1. DUMP - For spent chemistry. Connect to DUMP bottle or plumbed-in drain.
2. FLUSH - Disposes of spent FLUSH water. Connect to DUMP bottle or drain.
3. SAVE FIX - Recovers the solution to be saved. Active only when SAVE switch is
on (red is showing). Connect to separate bottle.
4. SAVE BLEACH - Recovers solution to be saved. Active when SAVE switch is on.
Connect to separate bottle.
5.
OVERFLOW - DO NOT CONNECT. If solution comes out of this outlet, check your
FLUSH tubing for proper installation.
Push the flexible tubing over the stainless tubes of these outlets (no more than 3/4”).
Position DUMP bottle close to unit. (Fig. 1)
Run tubing directly to DUMP bottle. (Fig. 1)
Cut off unneeded length of dump tubing. (Fig. 1)
Run the DUMP and the FLUSH tubing separately into the 3” gray
fitting on the DUMP bottle. Do not put a third tubing into the same
fitting.
Do NOT run tubing inside DUMP bottle. (Fig. 2). Allow at least 12” drop between unit and
DUMP bottle.
Open the DOOR by lifting up from the bottom and pulling out. Place the magnetic stirrer
(white pill) in the exposed heat tank. Carefully push the stirrer with a pencil until it is
magnetically caught near the back right corner of the tank. Turn SIDEKICK on and
check if the stirrer is turning.
Put in six Alkaline “C” Cells in the battery holder. This will allow the unit to continue after
a power failure and protect it against power surges. Plug the power cord into a 120 Volt
AC 15 Amp. (regular domestic) outlet.
VERY,
VERY,
IMPORTANT!