Sidekick SK-8RG, Руководство пользователя

Страница: 3 / 20

3
SETTING UP THE UNIT Cont.
Place the unit on a flat level surface. Lift up the side and cut away and discard the two
visible nylon straps from the bottom of the unit. These straps hold the pumps secure for
shipping and must be removed for the pumps to work.
Prepare the solution bottles. a) Loosen
NUT. b) push in notched end of the ¼ OD
black tubing through fitting to bottom of
bottle. Leave about 2 inches (5 cm)
exposed. c) Hand tighten nut. d) Rinse out
bottle. You can use the collapsible bottles
for developers, they will extend chemical
life because there is no air interface.
Use the marker pen to label each bottle and
lid with the chemical it contains. Cut a
piece of clear flexible tubing long enough
to run from the bottle to the back of the
machine. RUN THE TUBING STRAIGHT
DOWN from the back of the machine. After about a foot, the tubing can run in any
direction Allow about 2 feet (60 cm.) extra for slack. Label both ends of the tubing with
the chemical name. Slip one end over the proper tube and the other end over the
exposed black tubing of the solution bottle. The 5 gal. water bottle connects to the
WATER (#5) tube.
IMPORTANT. The solution source bottles must be located below the processor.
The 5 gal. water bottle, which
has a float valve near its lid,
holds the water that will be
used for processing and
internal cleaning (FLUSHING)
of the unit. You can manually
fill the bottle. Use regular tap
water, not de-ionized or
distilled water. You can
connect the bottle to a cold
water pipe for automatic filling
with the “ice maker” kit. TURN
OFF THE WATER AT THE
SOURCE WHEN THE MACHINE
IS NOT IN USE.
The DUMP bottle comes with a
level sensor that should be plugged into the DUMP SENSOR jack on the back of the unit.
IT WILL SENSE IF YOU HAVE ENOUGH ROOM FOR A 2 or 4 ROLL RUN ONLY. The bottle
must be emptied if you are doing a 6 or 8 roll run. If a plumbed-in drain is available, use
it.