Sicma TB-110, Инструкция по эксплуатации

Страница: 16 / 32

Sicma S.p.A.
Miglianico (CH)
page 16
After executing the above-mentioned activities it is always
good to check that all bolts and nuts of your shredder are
tightened strongly (refer to the bolts and nuts tightening
table described in this booklet).
Before attaching the equipment to the tractor, set both on a flat and smooth ground and make sure
that nobody is standing between them.
Move slowly the tractor towards the shredder by aligning the tractor elevator’s arms to the two
shredder hitches’ lateral gudgeons; stop engine and pull parking brake.
Connect first the lower arms by removing the release pins of the gudgeons placed on the plates ,
inserting the elevator bars into the arms centre and fastening them with the relevant release pins,
which had been removed in precedence.
Connect, afterwards, the tractor tie rod to the third upper point by removing the pin located
between the plates, inserting the tie rod itself and locking it with the pin.
Adjust the third point so that the upper part of the frame is parallel to the ground.
Lock all connection parts with the special sway chains or tie rods.
It is always good to make sure that the central group axis (sump/bevel gear pair) is parallel to the
ground thus reducing the stresses on the power takeoff and extending the working life of the
equipment.
Pay attention to the tractor’s front wheels grip when the
equipment is set up and lifted; if the wheels appear to be too
lightened, ballast the tractor front part.