2
Safety information
2.1
Intended use
InspectorP Rack Fine Positioning is suitable for rack fine positioning applications. The
device consists of a combination of an InspectorP 2D vision sensor (InspectorP621,
InspectorP63x) and a SensorApp (Rack Fine Positioning).
InspectorP Rack Fine Positioning is used for storage and conveyor applications. The
device supports the precise positioning of automated storage and retrieval systems
used for storing and retrieving load carriers. It supports positioning operations for
single-deep rack storage, and combined single-deep and double-deep rack storage
applications.
Management, commissioning and operation of the device is performed on a computer
using the SICK AppManager and SOPASair software programs. The device sends the
results to a higher-level controller (e.g., PLC) via the host interface for further central‐
ized processing.
SICK AG assumes no liability for losses or damage arising from the use of the product,
either directly or indirectly. This applies in particular to use of the product that does not
conform to its intended purpose and is not described in this documentation.
2.2
Improper use
Any use outside of the stated areas, in particular use outside of the technical specifica‐
tions and the requirements for intended use, will be deemed to be incorrect use.
•
The device does not constitute a safety component in accordance with the respec‐
tive applicable safety standards for machines.
•
The device must not be used in explosion-hazardous areas, in corrosive environ‐
ments or under extreme environmental conditions.
•
Any use of accessories not specifically approved by SICK AG is at your own risk.
WARNING
Danger due to improper use!
Any improper use can result in dangerous situations.
Therefore, observe the following information:
■
Product should be used only in accordance with its intended use.
■
All information in these operating instructions must be strictly observed.
■
Shut down the product immediately in case of damage.
2.3
Cybersecurity
To protect against cybersecurity threats, it is necessary to continuously monitor and
maintain a comprehensive and holistic cybersecurity concept. A suitable concept com‐
prises organizational, technical, procedural, electronic, and physical levels of defense
and provides suitable measures for different types of risks. SICK's products and solu‐
tions must be viewed as a component of this concept.
Information on Cybersecurity can be found at:
2.4
Limitation of liability
Relevant standards and regulations, the latest technological developments, and our
many years of knowledge and experience have all been taken into account when
compiling the data and information contained in these operating instructions. The
manufacturer accepts no liability for damage caused by:
SAFETY INFORMATION
2
8024534/1DQ8/2022-01-14 | SICK
O P E R A T I N G I N S T R U C T I O N S | InspectorP Rack Fine Positioning
7
Subject to change without notice
