Chapter
7
Operating Instructions
CLP 100 Bar Code Reader
Maintenance
26
©
SICK AG · Division Auto Ident · Germany · All rights reserved
8 008 912/0000/21-08-2002
The diagnosis mode can be selected directly in the terminal emulation window or set via the
tab cards:
¾
If the terminal emulator window is active: Click in the D
IAGNOSTIC
MODE
box and present
the bar code.
The reading process is started automatically. The CLP 100 scans the bar code once per
second.
- or -
1. If the terminal emulator window is not active: In the CLP Setup select the D
EVICE
CONFIGURATION
tab card.
2. Click in the O
PERATING
MODE
field and select D
IAGNOSTIC
MODE
.
3. Carry out the download to CLP 100.
The CLP 100 is in diagnosis mode.
4. Click on
in the CLP Setup toolbar.
The terminal emulator window opens.
5. Click on S
TART
READING
.
6. Present the bar code.
The CLP 100 outputs the read result in the window of the terminal emulator.
7. In order to return to reading mode proceed as described in
Section 6.5.3
.
6.6
Switching off the CLP 100
1. If the parameter set was changed, download the parameter set to the CP 100 and save
the parameter set as a configuration file in the CLP Setup.
2. Switch off the supply voltage.
The last parameter set saved in the CLP 100 remains valid.
7
Maintenance
7.1
Maintenance during operation
The CLP 100 reading window is made of glass. The reading window (
Figure 7-1
) must be
clean in order to achieve the complete reading performance of the CLP 100. Check the
reading window regularly for dirt in particular in case of dirty or humid environments.
If a sensor is used for triggering, its window and the reflector have to be cleaned regularly.
This avoids incorrect switching performance.
Fig. 7-1:
CLP 100 with front-end reading window (a) and side-end reading window (b)
b
a