SICE S 58 LL, Инструкция по эксплуатации

Страница: 72 / 256

72 - English - Operator's manual
16
A
B
WHEEL LOCKING OPERATION
The machine has a high pressure hydraulic circuit for the movements.
The pressure in this circuit can be adjusted by turning the handle (A, Fig. 16) as ex-
plained in the table.
Pressure adjustment range
from 50 to 180 bar
Normal operating pressure
180 bar
The pressure at which the machine is set can
be checked on the pressure gauge (C, Fig. 11)
by operating the turntable open control to its
end of stroke or by locking a rim.
NOTE.
When working with light alloy rims, it is
recommended to use the specific rings
supplied upon request (Fig. 17) in order
to prevent scratching or scuffing the rim.
WARNING
If the machine malfunctions, retreat to a
safe distance and turn the machine's main
switch (A, Fig. 11) to 0 (Fig. 18).
WARNING
Make sure that the rim is correctly and
firmly locked on every gripping point of
the turntable clamp.
WARNING
Any operation intended to modify the set-
ting value of the relief valves is forbidden.
The manufacturer declines all liability for
damage resulting from tampering with
these valves.
The pressure should be reduced for weak or particularly thin rims; for thick rims that
are difficult to demount, it is recommended to adjust pressure to the maximum level.
Adjust the opening of the turntable using the "closing/opening" control (C, Fig. 14) based on the
type of rim to lock (see examples in Fig. 19).
17
18