e005 OLIMPO
ver. 00
User’s manual
pag. 2 di 29
Printed in
e005-di OLIMPO (eng).doc
Siap+Micros S.r.l.
1.2 Warnings
The producer declines all responsibility if a fault is due to a disobedience of the instructions, tampering, any
use not stated in this manual, improper use of the unit, the use of the unit by untrained staff. Only authorized
and specially trained, qualified staff may have access to the working area for the standard maintenance and
operative purposes.
Safety measures
-
This unit should be connected to an electric earthing (or of safety).
-
The unit must not be used in the presence of inflammable gas, smoke or any other environmental risk of
explosion.
-
Do not remove, modify or substitute any electrical or mechanical part of the unit without authorization.
-
The substitution of any components and any internal intervention should be carried out only by qualified,
trained maintenance staff, after having disconnected the unit from the main power supply.
-
Pay attention to any warning notice against dangerous procedures.
1.3 Moving the unit
In order to avoid damaging the unit during transport procedures we recommend that the unit be kept in an
upright vertical position without shaking it.
1.4 Unpacking
Before unpacking the unit and installing it ensure that the following precautions have been taken:
-
Use protective gloves to avoid scratches and abrasions.
-
If any damage due to the transport procedures carried out by the supplier return immediately to the
supplier.
-
Once unpacked ,place the unit and its components on a flat surface.
-
Avoid turning the unit upside down.
-
Be careful with the electrical sockets placed at the front and back of the unit during the operations.
Before installing the unit check the following :
-
The tension of the network of the installing area complies with the unit's requirements.
-
Check the main switch of the unit is switched off.
-
Avoid switching on the unit before having carefully read the installation instructions indicated in this
manual.
1.5 During the functioning
During the functioning never open the internal door without having switched off the specific switch indicated
as PWR . After having switched off the unit open the internal door.
And deactivate the power line 220Vac by turning the magneto thermal switch situated on the right.
However, always wear suitable protective clothing necessary for such a working environment.