12
Step 2.
Set Jumpers
The default jumper settings have been set for the common usage standard of
this mainboard. Therefore, you do not need to reset jumpers unless you
require special adjustments as any of following cases:
1. Clear CMOS
2. Enable wake-up function of USB ports
3. The read-only status of BIOS
4. Onboard CODEC mode
5. Codec select
6. FSB speed select
For first-time DIY system builders, we recommend that you should not
change the default jumper settings if you are not totally familiar with
mainboard configuration procedures. The factory-set default settings are
tuned for optimum system performance. For the advanced users who
wish to customize their system, section
3.2 Jumper Settings
will provide
the detailed information on how to configure your mainboard manually.
Step 3
Install SDRAM System Memory
To install memory, insert SDRAM or VCM SDRAM memory module(s) in
any one, two or three DIMM banks. Note that SDRAM modules are
directional and will not go in the DIMM slots unless they are properly
oriented. After the module is fully inserted into the DIMM socket, lift the
clips of both sides of the DIMM bank to lock the module in place.
