60
Primary/Secondary Master / Slave UDMA
Each channel supports a master device and a slave device. This
motherboard supports UltraDMA. UltraDMA technology provides
faster access to IDE devices.
If you install a device that supports UltraDMA, change the appropriate
item on this list to Auto. You have to install UltraDMA driver supplied
by this motherboard in order to use an UltraDMA device.
!
The choice: Auto, Disable.
Init Display First
If install both PCI and AGP display card , use this item to define one as
primary display adapter.
!
The choice: AGP, PCI Slot.
IDE HDD Block Mode
Block mode transfers can improve access to IDE devices. Enable this
item if your IDE devices support block mode transfer.
!
The choice: Enabled, Disabled.
Onboard FDD Controller
This option enables onboard floppy disk drive controller.
!
The choice: Enabled, Disabled.
Onboard Serial Port 1,2
This option is used to assign I/O address for onboard serial ports.
!
The choice: 3F8/IRQ4, 2F8/IRQ3, 3E8/IRQ4, 2E8/IRQ3, Auto,
Disabled.
UART 2 Mode
This field is available if onboard serial port 2 field is set to any option
but Disabled. UART 2 Mode enables you to select the infrared commu-
nication protocol—Standard , HPSIR, or ASKIR. HPSIR is Hewlett
Packard’s infrared communication protocol with a maximum baud rate
up to 115.2 Kbps. ASKIR is Sharp’s infrared communication protocol
with a maximum baud rate up to 57.6 Kbps.
!
The choice: Standard, HPSIR, ASKIR
