Shure Incorporated
25/44
3.
1.
2.
•
•
•
•
•
•
•
•
•
•
•
EQ Application
Suggested Settings
Reduce the gain at the identified frequency (start be
tween -3 and -6 dB) to minimize the unwanted room
sound
EQ Contour
Use the EQ contour to quickly apply a high-pass filter at 150 Hz to the microphone's signal.
Select
EQ contour
to turn it on or off.
Encryption
Audio is encrypted with the Advanced Encryption Standard (AES-256), as specified by the US Government National Institute of
Standards and Technology (NIST) publication FIPS-197. Shure devices that support encryption require a passphrase to make
a connection. Encryption is not supported with third-party devices.
In Designer, you can only enable encryption for all devices in a room in live mode:
[Your
room]
>
Settings
>
Audio
encryption
.
To activate encryption in the web application:
Go to
Settings
>
Audio
encryption
>
Enable
encryption
.
Enter a passphrase. All devices must use the same passphrase to establish an encrypted connection.
Important:
For encryption to work:
All Shure devices on your network must use encryption.
Disable AES67 in Dante Controller. AES67 and AES-256 cannot be used at the same time.
Networking Best Practices
When connecting Shure devices to a network, use the following best practices:
Always use a "star" network topology by connecting each device directly to the switch or router.
Connect all Shure networked devices to the
same network
and set to the
same subnet
.
Allow all Shure software through the firewall on your computer.
Use only 1 DHCP server per network. Disable DHCP addressing on additional servers.
Power on the switch and DHCP server before powering on the Shure devices.
To expand the network, use multiple switches in a star topology.
All devices must be at the same firmware revision level.
Switch and Cable Recommendations for Dante Networking
Switches and cables determine how well your audio network performs. Use highquality switches and cables to make your au
dio network more reliable.
Network switches should have:
Gigabit ports. 10/100 switches may work on small networks, but gigabit switches perform better.
Power over Ethernet (PoE) or PoE+ ports for any devices that require power
