SHOWTEC NanoQ 12 Q4 V1, Руководство пользователя

Страница: 12 / 28

Ordercode: 43710
NanoQ 12 Q4
The NanoQ 12 Q4 can be operated with a controller in control mode or without the controller in stand-
alone mode.
Control Panel
A)
B)
C)
D)
E)
LCD Display
MODE button
SETUP Button
UP Button
DOWN Button
Fig. 05
Control Mode
The fixtures are individually addressed on a data-link and connected to the controller.
The fixtures respond to the DMX signal from the controller.
DMX Addressing
The control panel on the front side of the base allows you to assign the DMX fixture address, which is the
first channel from which the NanoQ 12 Q4 will respond to the controller.
Please note when you use the controller, the unit has 14 channels.
When using multiple NanoQ 12 Q4s make sure you set the DMX addresses right.
Therefore, the DMX address of the first NanoQ 12 Q4 should be 1(001); the DMX address of the second
NanoQ 12 Q4 should be 1+14=15 (015); the DMX address of the third NanoQ 12 Q4 should be 15+14=29
(029), etc.
Please, be sure that you do not have any overlapping channels in order to control each NanoQ 12 Q4
correctly.
If two or more NanoQ 12 Q4s are addressed similarly, they will work similarly.
Controlling:
After having addressed all NanoQ 12 Q4 fixtures, you may now start operating these via your lighting
controller.
Note: After switching on, the NanoQ 12 Q4 will automatically detect whether DMX 512 data is received
or not. If there is no data received at the DMX-input, the display text on the control panel will not flash.
The problem may be:
•
The XLR cable from the controller is not connected with the input of the NanoQ 12 Q4.
•
The controller is switched off or defective, the cable or connector is detective, or the signal wires are
swapped in the input connector.
Note: It’s necessary to insert a XLR termination plug (with 120 Ohm) in the last fixture in order to ensure
proper transmission on the DMX data link.
Display Off after 30 seconds
When no button is pressed for 30 seconds, the display will turn off.
To light up the display, you have to press the MODE, SETUP, UP or DOWN button.
Once you have pressed the button, the display will light up.
11