SHOWTEC NanoQ 12 Q4 V1, Руководство пользователя

Страница: 9 / 28

Ordercode: 43710
NanoQ 12 Q4
Control Modes
There are 6 modes: Auto run program
Built-in programs
Manual mode
Sound-controlled mode
Master / Slave
DMX-512 (6CH, 10CH or 14CH)
One NanoQ 12 Q4 (Auto run program, Built-in programs and Sound-controlled mode)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the NanoQ 12 Q4 is not connected with a DMX cable, it functions as a stand-alone device.
05) Please see page 13-14 for more information.
One NanoQ 12 Q4 (Manual Mode)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the NanoQ 12 Q4 is not connected with a DMX-cable, it functions as a stand-alone device.
05) Please see page 14 for more information about the manual mode functions.
Multiple NanoQ 12 Q4s (Master / Slave Control)
01) Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) Use a 3-pin XLR cable to connect the NanoQ 12 Q4s.
The pins: 01) Earth
02) Signal (-)
03) Signal (+)
05) Link the units as shown in (fig.03). Connect a DMX signal cable from the first unit's DMX "out" socket to
the second unit's "in" socket. Repeat this process to link the second, third, and fourth units. This means
that you can set your desired operation mode on the master device and all slave devices will react
the same as the master device.
Multiple NanoQ 12 Q4s (Master / Slave Set Up)
Fig. 03
8