
9
Ordercode: 50701
SM-16/2
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply. The device can be sound-controlled as it is equipped
with a built-in microphone.
Resetting the System
Warning: this will reset the controller to its factory defaults. This will erase all programs and settings.
01)
Turn off the unit.
02)
Press and hold down the BANK UP and AUTO/DEL buttons.
03)
Switch the unit on (while still holding down the BANK UP and AUTO/DEL buttons).
04)
All LEDs will blink to indicate a successful reset. This process may take up to 30 seconds.
Warning: This will reset the controller to its factory defaults.
This will erase all programs and settings.
Fixture Addressing
The SM-16/2 is programmed to control 32 DMX channels per fixture. Therefore, the fixtures you wish to
control with the corresponding FIXTURE buttons on the unit must be spaced 32 channels apart from each
other (check the respective fixture’s manual for how to enter the information into the fixture).
Note: failure to use these DMX assignments may cause a lack of control of the fixtures.
Physical Fader Assignment (optional setup)
Use this feature to combine or unify fixture control attributes for different fixtures. For example; if you were
controlling 4 moving mirrors and 4 moving yokes - the color, gobo and dimmer channels may not line up
ideally on the physical faders. Use this function to re-assign the dimmer, color and gobo
channels to faders 1, 2 and 3. From now on you will be able to control the same attributes on all
fixtures using the same fader location.
01)
Press and hold down the PROGRAM & TAPSYNC buttons to access the channel assignment mode.
02)
Press the FIXTURE button that represents the fixture whose faders you would like to re-assign.
03)
Move the SPEED fader until you arrive at controller channel (number).
04)
Move the FADE TIME fader to select the DMX channel.
05)
Press the MIDI/ADD button to confirm your setting.
06)
Repeat steps 3-5 as often as necessary. If you wish to copy a scanner’s physical assignments to
another scanner, follow steps 7-14. If you do not wish to do this, press and hold down the PROGRAM
& TAPSYNC buttons twice, to exit mode.
Example: Copying Scanner 1 to Scanner 2
07)
Press and hold down the PROGRAM & TAPSYNC buttons together 1 time to access the channel
assignment mode.
08)
Press and hold down FIXTURE button # 1.
09)
While holding down button # 1, press FIXTURE button # 2.
10)
While holding FIXTURE buttons # 1 and # 2, press and hold down the MIDI/ADD button.
11)
Release FIXTURE button # 1 first, before releasing FIXTURE button # 2.
12)
Release the MIDI/ADD button.
13)
All FIXTURE LED indicators will flash to confirm a successful copy.
14)
Press and hold down the PROGRAM & TAPSYNC buttons twice, to exit mode.
THE JOYSTICK IS PROGRAMMED TO CONTROL CHANNELS P1/P2 (X-AXIS) AND
T1/T2 (Y-AXIS) BY DEFAULT. FOLLOW THE INSTRUCTIONS FOR “PHYSICAL FADER
ASSIGNMENT” AND “REVERSE CHANNEL OUTPUT” TO RECONFIGURE THE
JOYSTICK.
Содержание 50701
Страница 20: ...2015 Showtec...