SHOWTEC 50335, Руководство пользователя

Страница: 9 / 24

7
Set Up and Operation
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
2.1 Begin Programming
2.1.1 Record Enable
1) Press and hold down the Record button.
2) While holding down the Record button, tap the Flash buttons 1, 6, 6 and 8 in sequence.
3) Release the Record button, the Record LED lights up, now you can begin programming your chase
patterns.
NOTE: The first time you turn on your unit, the default setting of the Record Code is Flash buttons 1, 6, 6
and 8.
You may change the Record Code to protect your programs.
2.1.3 Program Scenes
1) Record Enable.
2) Select the 1-24 Single mode by tapping the Mode Select button.
This will give you control of all 24 channels as you program.
Be sure that Master A & B are both set at maximum.
(Master A is at its maximum in the fully up position, while Master B is at its
maximum in the fully down position.)
3) Create a desired scene using Channel Sliders 1-24.
At 0% or DMX 0, these sliders should be at 0 position, and at 100% or DMX 255,
these sliders should be at 10 position.
4) Once the scene is satisfactory, tap the Record button to program the scene
as a step into the memory.
5) Repeat step 3 and step 4 until all desired steps have been programmed into memory.
You may program up to 1000 steps into memory.