SHOWTEC 50335, Руководство пользователя

Страница: 20 / 24

18
Tap-Sync-Button
1) The Tap Sync button is used to set and synchronize the chase rate (the rate at which all scenes will
sequence) by taping the button several times. The chase rate will synchronize to the time of the last two
taps. The LED above the Step Button will flash at the new chase rate. The chase rate may be set anytime
whether or not a program is running.
2) Tap Sync will override any previous setting of the speed slider control until the slider is moved again.
3) Use of Tap Sync in setting a standard beat is the same with speed control slider.
Master Slider
Master Slider control provides proportional level control over all channels and scenes with the exception of
the Flash Buttons.
For example:
Whenever the Master slider control is at minimum all stage outputs will be at zero except for any resulting
from a Flash Button or FULL ON Button. If the Master is at 50%, all outputs will be at only 50% of the setting of
current channel or scenes except for any resulting from a Flash Button or FULL ON Button.
If the Master is at full all outputs will follow the unit setting. Master A always controls outputs of channels.
Master B controls the program or a scene except in Double Preset Mode.
Single Mode
1) All programs will run in sequential order starting in the order of program number.
2) The Segment Display will read the running program number.
3) All programs will be controlled by the same Speed Slider.
4) Press the MODE SELECT BUTTON and select " CHASE
SCENES".
5) Press the PARK BUTTON to select SINGLE CHASE MODE. A red LED will indicate this selection.
Mix-Mode
1) Will run all programs synchronously.
2) All programs can be controlled by the same SLIDER SPEED, or each programs speed may be controlled
individually. (See Speed Setting ).
3) Press the MODE SELECT BUTTON and select "CHASE
SCENES".
4) Press the PARK BUTTON to select MIX CHASE MODE. A yellow LED will indicate this selection.
Dimmer-Display
1) The 3-Digit Segment Display is used to display intensity percentage or absolute DMX value.
2) To change between percentage and absolute value:
Press and hold the Shift/Record Button. While holding down the Shift button press the % or 0-255 Button
to switch between percentage and absolute values.
3) If the Segment Display reads, for example, "076", it means a percentage value 76%.
If the Segment Display reads "076", it means the DMX value 76.
Blind and Home
1) Blind function takes channels temporally out from a chase, when the chase is running, and gives you
manual control over the channel.
2) Press and hold the Blind Button and tap the relative Flash Button you want to temporarily take out of the
chase.
3) To return to normal chase again press and hold the Home Button and push the Flash Button you want to
return to normal chase.