SHOWTEC 50335, Руководство пользователя

Страница: 21 / 24

19
Park
1) In CHASE
SCENES Mode, press down the button you can change the chasing mode of programs
between Single Mode and Mix Mode.
2) In Double Preset Mode, pressing down this button is equal to pushing Master Slider B to the top.
3) In Single Preset Mode, this button could temporally record current output, with Master Slider B to adjust.
Add and Kill
The ADD/KILL Button changes the mode of the flash buttons. Normally the flash buttons are in Add mode,
whereas pressing any flash button will not kill other scenes, allowing multiple scenes to be on at a time.
The Kill mode is activated by pressing the Add/Kill button and illuminating the LED above it. Pressing any flash
button will kill other active SCENE or Program. In Kill Mode, the killed program does not stop running but can
not output.
Double Preset
1) Press Mode Select Button to enter A Double Preset Mode.
2) In this mode, Channel Sliders 1-12 and channel sliders 13-24 both control Channel 1-12
3) Master A controls channel Slider 1-12 while Master B controls Channel Sliders 13-24.
4) In this Mode, no scene could be recorded.
Example
1) Enter the Double Preset Mode.
2) Push Channel Sliders 1 to 6 to the top and move Channel Sliders 19 to 24 to the maximum.
3) Move Master A and B to the same level and push them to the same direction, you will get a scene.
Attention!
1) To retain your programs from loss, this unit must be powered not less than two hour every month.
2) The Segment Display shows "LOP" if the voltage is too low.