ADM-880C 07/20/09
16
STD DENS s
This prompt indicates that standard density is being selected using the meter configuration loop.
STORE ALL
This message indicates that the meter will store every following reading in sequence.
STORE FULL
This message indicates that the number of readings in memory has reached the maximum storage capacity of 2000
readings.
STORE LAST
This message indicates that the meter has been placed in the STORE LAST mode and the reading on display [nn?
nnn] will be saved when the user presses the READ.
STORE MODE
This message is displayed as part of the [STORE MODE / NOT ALLOWD] sequence to indicate that the meter is
in the STORE mode. The units and density may not be changed while readings are being stored in the current
memory group.
STORE OFF
This message indicates that the meter is not in the STORE mode.
TEMP
This signal will be flashed when the temperature measurement mode is selected, and also upon each subsequent
operation of the READ key. It is also displayed as part of the sequence of displays when ASSOCIATED reading is
selected following an air flow or velocity reading. It precedes the display of the temperature associated with that
reading.
TEMPROBE
This message is displayed as part of a display sequence to indicate a change in the TemProbe connection status
during a STORE sequence.
TEMPROBE / CHANGE / NOT ALLOWD
This message is displayed if the TemProbe status is changed while readings are being stored in an air flow or
velocity measurement mode. A change in the TemProbe setup while storing air flow or velocity readings requires
the user to select a new memory group, as readings stored with actual and standard temperatures must not be
averaged together.
TIME s
This is the third option available when the user presses the MODE key repeatedly after selecting the CONFIGURE
mode, and is used to change the time settings in the meter.
TIMED DONE
This message indicates that the meter has completed a TIMED READ sequence as programmed by the user.
TIMED READ
This message is displayed just prior to the first reading when the meter begins a TIMED reading sequence.
TIMED RDY / PRESS READ
This message is displayed when the user completes the configuration of a TIMED READ. When the READ key is
pressed, the meter begins the waiting period prior to the Begin Time. If the user did not program a Begin Time, the
meter will begin the programmed reading process when the READ key is pressed.
TIMED WAIT
This message indicates that the meter is in the waiting interval between TIMED readings..
TOO HOT or TOO COLD
If the internal temperature of the meter exceeds its operational limits, it will display [TOO HOT] or [TOO COLD] and
shut down. The meter will retain any readings in memory. The meter must be cooled down or warmed up, as the
case may be, before normal operation can be resumed. If the meter has displayed [OVER RANGE] after displaying
either [TOO HOT] or [TOO COLD], but has not shut down, this message indicates that the TemProbe sensor was
being exposed to temperature levels beyond the proper operating range. If [TOO HOT / OVER RANGE] has been
displayed, but the meter has not shut down, the TemProbe sensor may be short circuited.
Содержание AIRDATA ADM-880C
Страница 42: ...ADM 880C 07 20 09 37 FIGURE 6 3 VELGRID ASSEMBLY...
Страница 50: ...ADM 880C 07 20 09 45 FIGURE 10 1 FRAME STORAGE FIGURE 10 2 FLOWHOOD IN CASE...
Страница 51: ...ADM 880C 07 20 09 46 FIGURE 10 3 FLOWHOOD ASSEMBLY...
Страница 53: ...ADM 880C 07 20 09 48 FIGURE 10 7 1X5 FRAME ASSEMBLY FIGURE 10 8 3X3 FRAME ASSEMBLY...
