Shortridge Instruments AIRDATA ADM-880C, Руководство по эксплуатации

Страница: 16 / 73

ADM-880C 07/20/09 11
store sequence within the same memory group.
AUTO ZERO
When the meter is first turned ON, it will perform a self-calibration process that takes a few seconds. The display
will read [AUTO ZERO] during this period and the operating controls will be inhibited. No READ operations or
function changes may be made during the AUTO ZERO period. The meter will also perform a brief self-calibration
cycle periodically throughout normal operation.
BATTERY
This message will appear as part of the [NO LIGHT / BATTERY / TOO LOW] display sequence, when the battery
charge is too low to support use of the light.
BATT 1/3
This message indicates that about 1/3 of the useful battery charge remains. This message is displayed every five
minutes in MANUAL reading mode and also after pressing ALT / ALT.
BATT 2/3
This message indicates that about 2/3 of the useful battery charge remains. This message is displayed every five
minutes in MANUAL reading mode and also following ALT / ALT.
BATT FULL
This message indicates that the batteries are fully (or close to fully) charged. This message is displayed every five
minutes in MANUAL reading mode and also following ALT / ALT.
BEGIN WAIT
This message indicates that the meter is in TIMED READ mode and is waiting for the Begin Time to occur.
CALC STATS
This message is displayed while the meter is calculating the statistics for a large memory group.
CHANGE
This message indicates that a connection to the meter, such as the TemProbe, has been altered. [CHANGE] may
be preceded by the display of the connection type.
CHANGE MEM
This message is flashed when the user presses ALT / STORE / ALT / STORE to access the function to select a new
memory group, erase a reading or replace a reading in memory.
CHANGE / NOT ALLOWD
This message is displayed in sequence with other messages to indicate that a selected function is not available.
CHG GROUPs
This message is displayed to prompt the user to press the SELECT key to select a new memory group.
?CLR ALL? s
This message indicates that the meter has more than 50 readings in one memory group or is using more than one
memory group and all readings will be deleted from memory when the READ / SELECT key is pressed.
CLEAR
This message is displayed when the operator has pressed ALT / STORE / SELECT and no readings are in memory.
CLEAR AUTO
This message is flashed if the user presses ALT / READ to display [AUTO READY] , then presses ALT / STORE
/ SELECT. The meter displays this message briefly and returns to the MANUAL reading mode.
CLEAR MEMs
This message is displayed when the operator has pressed ALT / STORE, and is the prompt to press the READ key
to clear all readings in memory.
CLEAR TREN
This message is flashed if the user presses ALT / READ / ALT / READ to display [TREND RDY], then presses ALT
/ CLEAR / SELECT. The meter displays this message briefly and returns to the MANUAL reading mode.