9
Attaching The
Shoulder Strap
To Wear the Shoulder Strap
1. Hook the strap hook to the hanger on
the outer pipe.
. Wear the shoulder strap so that the hook
stays at your right hand side.
3. Adjust the length of the shoulder strap
so that you can hold and operate the
machine comfortably.
Shoulder Strap
Emergency Release
In case of emergency, firmly pull the
white tab at the hook. The machine will be
released from the strap.
Using the Pole Pruner
This machine is designed especially for
cutting branches. Never use this machine
for any other purposes. Never try to cut
stones, metals, plastics or any other hard
objects.
Using for other purposes than cutting
branches may damage the machine or
cause serious injury.
Preparations
• Wear suitable protective clothing and
equipment; see “Safety Precautions”
section.
• Choose the best work position for safety
against the falling object (Branch etc)
• Start the engine.
• Put on the strap.
Never stand underneath the branch you
are cutting–be wary of falling branches.
Note that a branch may spring back at you
after it hits the ground.
Cutting sequence
To allow branches a free fall always cut
the lower branches first. Prune heavy
branches (large diameter) in several
controllable pieces.
Working position
Hold the control handle with your right
hand, and the shaft with your left hand.
Your left arm should be extended to the
most comfortable position.
The shaft should always be held at an
angle of 60° or less.
NOTE:
Take a rest when you feel fatigue.
Typical applications
Standard cut:
The most convenient working position
is a tool angel of 60°, but any other
angle may be used to suit the situation
concerned.
Cutting above obstacles:
Thanks to the unit’s long reach it is
possible to prune branches that are
overhanging obstacles, such as rivers or
lakes. The tool angle in this case depends
on the position of the branch.
Cutting on a work platform:
The unit’s long reach enables cutting to be
performed next to the trunk without the
risk of the work platform damaging other
branches.
The tool angle in this case depends on the
position of the branch.
Содержание SBA-P24
Страница 42: ...Italiano NOTA IT_14 ...
Страница 43: ...Italiano NOTA IT_15 ...