SHERCO 2014 250 SEF-R, Руководство по ремонту

Страница: 37 / 75

•
Install the special tool that locks the
engine at top dead center (ref 1819).
•
Use tool 1817 to block the transmission
ant to tighten balancer nut.
Torque
of balancer nut 60 Nm
threadlocker.
•
Install the oil pump drive roll pin
intern rotor and fixing nut to the cover
Torque of the oil pump cover
•
Heat the crankshaft spacer ring (ref
1732) to approximately 70 degrees and
on the crankshaft.
•
Replace the freewheel assembly and the
starter drive gear train (see the paragraph on
disassembling the left side).
•
Reinstall the starter.
•
Reinstall the motor top end (see the
paragraph on the top end).
•
Install the cam drive
paragraph on top end).
•
Install the clutch (see the paragraph on
disassembling the right side).
•
Install the clutch cover.
•
Install the spark plug.
Torque the spark plug to: 15 Nm.
Apply threadlocker to all of the internal
engine threads except the five clutch pressure
plate fixing screws.
Install the special tool that locks the
engine at top dead center (ref 1819).
Use tool 1817 to block the transmission
Torque of balancer nut 60 Nm +
Install the oil pump drive roll pin, the
fixing nut to the cover.
Torque of the oil pump cover : 5 Nm.
Heat the crankshaft spacer ring (ref
1732) to approximately 70 degrees and install it
Replace the freewheel assembly and the
starter drive gear train (see the paragraph on
Reinstall the motor top end (see the
Install the cam drive chain (see the
Install the clutch (see the paragraph on
Torque the spark plug to: 15 Nm.
to all of the internal
ept the five clutch pressure
37/75