SHERCO 2014 250 SEF-R, Руководство по ремонту

Страница: 36 / 75

36/75
•
On the right hand case make sure the
breather jet is in place.
•
Place the right case on the left case
previously fabricated.
•
Install the 13 screws that retain the two
halves together.
Torque the 13 center crankcase screws to:
10 Nm.
•
Install special tool number 2073 to keep
the gear selector drum from rotating.
•
Install the locating pin, the gear selector
index wheel and the fixing screw.
Torque the gear selector index wheel fixing
screw to: 10 Nm.
•
Remove the special tool number 2073.
•
Install the gear selector shaft.
•
Install the oil pump shaft, the roll pin and
the internal oil pump rotor.
•
Install the oil pump cover and tighten the
cover screws to the appropriate torque.
Torque the oil pump cover screws to: 5 Nm.
•
Install the oil pump drive roll pin, the
drive gear and the cir clip.
•
Install the primary drive gear.
•
On the transmission input shaft install
the thrust washer, the needle bearings the
clutch basket, the spacer washer, the clutch
hub and the conical washer.
•
Using an appropriate solvent clean the
crankshaft threads and the input shaft threads.
•
Install the fixing nuts on the crankshaft
and the transmission input shaft.
•
Apply the proper torque these fixing
nuts.
•
Install special tool number 1817 and
torque the crankshaft fixing nut.
Torque the crankshaft fixing nut to: 120 Nm.
•
With the special tool still installed, torque
the transmission input fixing nut.
Torque the transmission input fixing nut to:
80 Nm.