Shaver Grand Slam, Руководство оператора и каталог запасных частей

Страница: 28 / 56

28
2. Raise or lower the storage legs (small
arrows) to allow drive ram I-beam (large
arrow) full contact with the ground.
Make sure the Post Driver is stable.
Drive Ram and Storage Legs.
NOTE : On units without storage legs, store
the unit against a post driven into the ground.
Position the unit with the driving ram next to
the post and secure with a chain wrapped
securely around the post and Post Driver.
On hydraulic tilt Post Drivers, to
prevent the forward tilt cylinder
from drifting, tighten the bolt and
nut on the cylinder scissor stop.
Failure to tighten this bolt and nut
could allow the dismounted Post
Driver to fall over, causing serious
injury or even death
.
3. On hydraulic tilt Post Drivers, tighten the
nut on cylinder Scissor Stop bolt (see
arrow below) to prevent the cylinder from
drifting and causing an unstable condition
with the Post Driver.
Cylinder Scissor Stop Bolt.
NOTE: Failure to tighten this bolt could
allow the Post Driver to fall over, causing
serious injury or even death.
4. Make sure all pressure is r e l e a s e d (zero
pressure) from the Post Driver hydraulic
system.
Disconnect hydraulic pressure
supply hose (A) from the tractor or skid
loader
.
Disconnect hydraulic return hose (B)
from the tractor or skid loader, see below.
Hydraulic Pressure Supply Hose (A), Hydraulic Return
Hose (B), Top Link Pin (C), and Lower Lift Arms (D).
5. For 3-Point Hitch remove top link pin (C)
from weldment and disconnect top link.
Then disconnect the two tractor lower lift
arms from the lower hitch pins
(D) to
separate the tractor three-point hitch from
the Post Driver, see above.
6. Carefully move the tractor or power source
away from the Post Driver.
A
B
D
D
C