Shaver Grand Slam, Руководство оператора и каталог запасных частей

Страница: 29 / 56

29
Service Procedures
To avoid personal injury or death,
carefully read and understand all
instructions before attempting to
assemble
and/or operate the
P o s t Driver. Do not operate or
work on equipment unless you read and
understand the instructions and warnings
in this and all other applicable manuals.
Contact Shaver Manufacturing Company if
any
of the instructions provided are
unclear or not understood. Proper care is
your responsibility. Always follow all State
and Federal health and safety laws and/or
local regulations.
To help prevent personal
injury,
protective
equipment must be worn
during
Post Driver
assembly, operation, and
maintenance.
Personal
protective equipment
should include, but n o t
b e limited to,
safety
glasses, hearing protection, protective
gloves, and steel toe footwear.
Before making any
adjustments on the Post
Driver, ensure that all
hydraulic levers are in the
neutral position. Always
shut off the machine, set parking brake, and
remove key before performing any service.
Personal injury can result
from slips or falls. DO
NOT leave tools or parts
lying around the work
area, and clean up all
spilled fluids immediately.
NOTE : Disassembly, assembly, and/or
associated repairs must be performed with
the main carriage channel and drives ram in a
horizontal position, such as on a suitable
pallet, or heavy-duty support stands.
Refer to Dismounting Post Driver from
Machine/Power Source section for steps to
remove Post Driver from a tractor or other
power source.
Dismounting Post Driver
from Base Plate
1. Secure the Post Driver upright to an
appropriate overhead lifting device to
prevent tipping (large arrow below).
Proper lifting device (large arrow above) when detaching
Driver from Base Plate.
2. Disconnect drive cylinder to valve hose and
drain fluid into a suitable container.
3. On Hydraulic Base Plate tighten Cylinder
Stop Bolt and nut (
‘
B
’
above). Disconnect
four tilt cylinder hoses from hydraulic control
valve, and drain the fluid into a suitable
container.
4. Remove cotter pins and two ( 2 ) B a s e
P l a t e
P i n s (
‘
A
’
a b o v e ) that
connect the Base Plate to the Post Driver.
NOTE : If necessary, lubricate channel mounting
pins with penetrating oil to assist pin removal.
5. The upright assembly is heavy. Use an
appropriate lifting device to position the Post
Driver assembly horizontally, on suitable
stands, pallet, or blocks on the ground.
A
A
B
A
WARNING