Sharp R-952M, Руководство по эксплуатации

Страница: 9 / 36

7
E
900W
MAFF HEATING CATEGORY
Model R-952M has a microwave output power of
900 Watts; heating category E.
The heating category (a letter A to E) was
developed by MAFF (Ministry of Agriculture,
Fisheries and Food) with microwave oven and food
manufacturers and indicates the ability of the oven
to heat small quantities of food (up to 500g [1lb
2oz]). It does not represent the general
performance of the oven.
Microwave output power in
watts (based on international
(IEC 705) standard).
600 700 800 900 1000 Watts
OVEN
OUTPUT
POWER
Less heating time required
More heating time required
Letter representing the oven
heating category.
Microwave
Symbol.
A B C D E
OVEN
OUTPUT
CATEGORY
Less heating time required
More heating time required
Food packs carry cooking instructions for heating
categories A to E. Follow instructions for the letter
corresponding to the oven's heating category.
The higher the output power and heating category
of the oven the less heating time is required, as
shown opposite.
Your oven is fitted with a 12 hour clock. To set the time of day, follow the guidelines given in the example below:
EXAMPLE:
To set the time of day, 12:35.
5. Press the AUTO START/ CLOCK
key again to set the clock.
1. Press the AUTO START/CLOCK
key once.
Check the display.
3. Press the AUTO START/
CLOCK key again.
4. Enter the minutes by pressing the
10 MIN key three times and the
1 MIN key five times.
2. Enter the hours, by pressing
the
10 MIN key once and
the 1 MIN key twice.
NOTES:
• If the oven is in cooking or timer mode and you wish to know the time of day, press the AUTO START/CLOCK key.
As long as your finger is pressing the key, the time of day will be displayed.
• If the electrical power supply to your microwave is interrupted, plug in the oven again, then open and close the door.
The display will show “ .0”. If this occurs during cooking, the programme will be erased. The time of day will also be
erased.
• If the clock is set and cooking is complete, the display will show the correct time of day. If the clock has not been set,
the display will show ” .0”.
x1
x1
x1
x2
x3
x5
x1
SETTING THE CLOCK
R-952M O/M FINAL 1/7/99 2:03 pm Page 7