Sharp PN-655E, Руководство по эксплуатации

Страница: 47 / 252

ENGLISH
45
E
■
If execution of the command is taking some time
When the following commands are used, “WAIT” is returned. In this case, a value will be returned if you
wait a while. Do not send any command during this period.
No ID number is attached to WAIT response.
• Commands which return WAIT:
- When repeater control is used
- When an IDSL or IDLK command is used
- When one of the following commands is used: RSET, INPS, ASNC, WIDE, EMAG, EPOS, PXSL,
POWR, AGIN, MWIN, MWIP, MWPP
■
When control via RS-232C is locked (to prevent use) using the operation lock function (see
page 26)
■
If the current parameter is read out using “?” for the parameter (for numerical values etc.)
• Response when no ID number has been set
Example:
VOLM????
10
• Response when an ID number has been set (In the example below: ID number = 1)
Example:
VOLM????
10
001
<Communication interval>
• After OK or ERR is returned, you must send the following commands. To set a timeout for the
command response, specify 10 seconds or longer.
• Provide an interval of 100 ms or more between the command response and the transmission of the
next command.
I W T A
Return code
(0D
H
, 0A
H
)
E C D K O L
Return code
(0D
H
, 0A
H
)
VOLM0020
OK
INPS0001
WAIT
OK
Interval of 100 ms or more