MX-M503N MX-KBX2 23 – 3
4)
Remove the screws and disconnect two connectors. Place the
operation panel upside down on the protection sheet.
*1: Don't pull the lead wire. The connector can be locked.
Hold the housing section of connector, pull out it.
*2: Slowly pull the lead wire and disconnect the connector.
*3: There is a locking section on the reverse side. Use care for
that.
5)
Remove the screw, and remove the panel angle.
6)
Install the keyboard unit (part No.1 in the package), and fix it
with the fixing screw A (part No.5 in the package) and the fixing
screw B (part No.6 in the package).
* When fixing the fixing screw B, use the short screwdriver or
the small screwdriver.
D. Install the operation panel
1)
Check that each harness is engaged with the rib.
2)
Connect the connector.
3)
Install the operation panel to the main unit, and fix it with the
screw.
*1: Be careful to the place of the connector lock, it is on the
other side.
*2: Insert the connector all the way.
4)
Remove the screw, and remove the operation base plate B
from the operation base plate unit.
*1 *3
*2
*1
*2
