MX-M503N MX-RP11 28 – 3
C. RSPF parallelism adjustment
1)
Make an RSPF parallelism adjustment sheet.
Cut copy paper in the longitudinal direction.
2)
Perform the adjustment according to the flowchart below.
1
20mm
A4/Letter size
<Flow chart>
<Work procedure>
a) Check section A.
Yes
No
Adjust hinge D
until there is a
resistance in
section A.
(Counter-
clockwise)
*
Check to insure that a slight resistance is felt when pulling out
the RSPF height adjustment sheet.
Slowly pull out the RSPF height adjustment sheet.
Place the RSPF height adjustment sheet between section A
and the RSPF glass height adjustment resin surface (a), and
close the RSPF unit.
b) If it cannot be pulled out, loosen the fixing nut and turn the section
D clockwise to lift the RSPF unit, and make an adjustment.
If it can be pulled out without resistance, loosen the fixing nut
and turn the section D counterclockwise to move down the
RSPF unit, and make an adjustment.
Be careful not to cover the convex section of the glass
holding resin surface with the height adjustment sheet.
Start of the
adjustment
Check section A.
Is
there a resist-
ance?
The section
A is lowered
too much.
Turn the hinge
D to lift the
RSPF so that
there is a
resistance in
the section A.
(Clockwise)
a
A
D
: '10/Jun/18
1