Sharp FO-1850, Руководство по обслуживанию

Страница: 34 / 120

CHAPTER 3. MECHANISM BLOCKS
[1] General description
1. Document feed block and diagram
Fig. 1
2. Document feed operation
1) The original, which is set in the document hopper, feeds automati-
cally when the front sensor is activated. This is turn activates the
pulse motor which drives the document supply roller. The docu-
ment stops when the lead edge is detected by the document
sensor.
2) The lead edge of the original is fed a specified number of pulses
after the lead edge of the document is detected for the reading
process to begin.
3) The trailing edge of the original is fed a specific number of pulses
after the trailing edge of the document deactivates the document
sensor. The read process then stops and the original is dis-
charged.
4) When the front sensor is in the OFF state (any document is not
set up in the hopper guide), the drive will be stopped when the
document is discharged.
3. Hopper mechanism
3-1. General view
Fig. 2
The hopper section contains document guides that are used to adjust
the hopper to the width of the original document. This ensures that
the original feeds straight into the fax machine for scanning.
Document width: 148 mm to 216 mm (A5 longitudinal size to Letter
longitudinal size)
NOTE: Adjust the document guide after setting up the document.
3-2. Automatic document feed
1) Use of the paper feed roller and separation rubber plate ensures
error-free transport and separation of documents. The plate spring
presses the document to the paper feed roller to assure smooth
feeding of the document.
2) Document separation method: Separation rubber plate
Fig. 3
3-3. Documents applicable for automatic feed
4x6 series
(788mm x 1091mm x
1000mm sheets) Square
meter series
Minimum Maximum Minimum Maximum
Feeder capacity 20 sheets, max.
Paper weight 45kg 64.3kg 52g/m
2
74.3g/m
2
Paper thickness (ref.) 0.06mm 0.09mm 0.06mm 0.09mm
Paper size B6 (128mm x 182mm)
∼
A4 (210mm x 297mm), Letter (216mm x 279mm)
NOTE: Double-side coated documents and documents on facsimile
recording paper should be inserted manually. The document
feed quantity may be changed according to the document
thickness.
Documents corresponding to a paper weight heavier than 64.3kg
(74.3g/m
2
) and lighter than 135kg (157g/m
2
) are acceptable for man-
ual feed.
Documents heavier than 135kg in terms of the paper weight must be
duplicated on a copier to make it operative in the facsimile.
3-4. Loading the documents
1) Make sure that the documents are of suitable size and thickness,
and free from creases, folds, curls, wet glue, wet ink, clips, staples
and pins.
2) Place documents face down in the hopper.
i) Adjust the document guides to the document size.
ii) Align the top edge of documents and gently place them into
the hopper. The first page under the stack will be taken up by
the feed roller to get ready for transmission.
NOTES: 1) Curled edge of documents, if any, must be straighten
out.
2) Do not load the documents of different sizes and/or
thicknesses together.
Separation
rubber
Separate
plate
Separate
spring
Document guide,
upper
Document guide,
lower
Document
sensor lever
Hopper guide
Feed roller 2
Pinch roller 2
Pinch roller
spring 2
Pinch roller
spring 1
Pinch roller
Paper feed roller
Paper feed spring
Front sensor
Paper feed spring
Separation rubber
Paper feed roller
FO-1850TH
3 – 1