Sharp AL-1633, Руководство по эксплуатации

Страница: 33 / 84

31
2
INTERRUPTING A COPY RUN
(Interrupt copying)
A copy run can be temporarily interrupted to allow another copy job to be performed. When the other job is finished,
the copy run will resume using the original copy settings.
1
Press the [INTERRUPT] key ( ) to
interrupt the copy run.
The INTERRUPT
indicator will light up and
the machine will revert to
the initial settings. (p.15)
The INTERRUPT
indicator will blink until
the current copy run
stops.
2
Remove the previous original(s) and
place the original(s) of the interrupt
copy job.
3
Set the number of copies and other
copy settings and then press the
[START] key (
).
The copy will be
delivered to the paper
output tray slightly offset
from the copies of the
interrupted run. (Offset
function)
The offset function can
be disabled in the user
programs. (p.39)
A: Copies made before the interrupt copy job
B: Interrupt copy job
C: Copies made after the interrupt copy job
4
When the copy job is finished, press
the [INTERRUPT] key (
) and remove
the original(s).
The INTERRUPT indicator will go off, indicating
that the interrupt function is no longer operating.
The copy settings will automatically revert to the
settings selected for the copy run before the run
was interrupted.
5
Replace the previous original(s) and
press the [START] key (
).
The interrupted copy run will resume.
Interrupt copying is not possible when the user programs are being configured, or scanning is being performed.
Note
• If the SPF is being used, the copy run will
not stop until the set number of copies is
completed.
• If "Auditing mode" is enabled:
"- - -" will appear in the number of copies
display. Enter your 3-digit account number.
Copying will not be possible unless a
correct account number is entered. (p.43)
INTERRUPT
Note
B
C
A
AL-1633_1644_EX.book 31 ページ ２００３年１０月２３日 木曜日 午後８時２１分