sharkclean .com
sharkclean .com
PREP YOUR HOME
USING
THE SHARK® AI ROBOT
IQ NAVIGATION™ AND AI LASER VISION
After setup is complete, your robot will conduct an
Explore Run
to create an initial map of your home.
The robot will travel from room to room to identify
walls, furniture, and other obstacles as it cleans.
This run will take less time than a full cleaning, as it
doesn’t cover the entire floor.
The robot's object detection technology helps it
navigate around obstacles taller than 2.8" in height.
Create no-go zones in the app to block off areas
you do not want the robot to enter. You can set up
no-go zones around small objects, or use them to
block off large areas.
MANUAL CLEANING MODE
To manually start a cleaning cycle, press the
Clean
button on the robot or on the mobile app. To
immediately send the robot back to the dock, press the Dock button.
NOTE:
scheduling can only be done in the app.
Your robot uses an array of sensors to navigate around walls, furniture legs, and other obstacles while it
cleans. To prevent the robot from entering areas you don't want it to, set up no-go zones in the app. For
best results, prepare your home as indicated below, and schedule a daily cleaning to ensure all floor areas
are regularly maintained.
NOTE:
Be sure to charge the robot completely before its first cleaning so that it can explore, map, and clean as much of
your home as possible. It may take up to 6 hours to fully charge your robot.
NOTE:
Avoid moving the dock. If it is relocated, the robot may not be able to find its way back to the dock. If the robot is
relocated while in use, it may not be able to follow its intelligent cleaning path, or find its way back to the dock.
OBSTRUCTIONS
Clear cords and objects
smaller than 2.8" in height
from floors and open interior
doors to ensure a complete
map of your home.
SCHEDULING
Schedule whole-home
vacuuming runs with the app.
THRESHOLDS
Your robot can easily climb
over most thresholds, but if
one is too high, set up a no-
go zone in the app to block
it off.
AVOID MOVING THE
ROBOT & DOCK
While your robot is cleaning,
do not pick it up and move it,
or move the charging dock—
this will impact the robot’s
navigation and ability to
return to dock when cleaning
is complete.
STAIRS
Your robot’s cliff sensors will
prevent it from falling off
ledges. For the cliff sensors
to work properly in any
mode, all runners, rugs, or
carpets must be at least 16
inches from any stairs, or
must extend over the edge of
the stairs.
