sharkclean .com
sharkclean .com
DOCK SETUP
INSTALLING THE SIDE BRUSHES
Snap the 2 included
Side Brushes
onto the square
pegs on the bottom of the robot.
If the robot has no charge or it cannot return to the
dock, manually place it on the dock. The indicator
light will flash and the robot will beep when
charging begins.
When the cleaning cycle is complete, the battery is
low, or when programmed to in a recharge/resume
mission, the robot will search for the dock. If the
robot doesn't return to dock, its charge may have
run out.
CHARGING
IMPORTANT:
The Shark® AI Robot has a pre-installed rechargeable battery. Charge the battery completely
before first use. It may take up to 6 hours to fully charge.
To charge, place the robot on the dock. The
Power
button on the side of the robot must be in the ON
position (I). The robot will beep when charging begins.
NOTE:
When manually placing the robot on the dock, make sure the
Charging Contacts
on the bottom of the robot are
touching the ones on the dock. While the robot is charging, both white LED lights will flash. When charging is complete,
lights will illuminate steadily.
NOTE:
When picking up the robot, be careful not to place fingers between the bumper and the base of the robot.
5 ft.
3 ft.
3 ft.
• Select a permanent location for the
Charging Dock
, because every time you relocate it, your robot will
have to completely re-map your house.
• Place the dock with its back against a wall. Select a level surface on bare floor, in a central area. Do not
place dock against baseboards or heating elements.
• Remove any objects that are closer than 3 feet from either side of the dock, or closer than 5 feet from the
front of the dock.
• Plug charging cord into an outlet. The dock must be plugged in continuously for the robot to find it.
