Sharebot Next Generation XXL+
user's manual
material, but the extruder will have to travel a lot more "journey" because of the greater number of layers to be created, even if each is made with less material and
therefore the total does not change.
Each type of object has its own range of optimal thicknesses for printing and only with a little experience you can operate on this parameter knowing what you are going
to realize actually.
Our advice is to think more about orientation of the model: the same object printed with different orientations, will have different surface finishes,
precisely depending on how it is "sliced" and rebuilt. From this point, the height layer is a secondary parameter.
The definition on the two axes X and Y is not controllable by the user, resulting from the geometry of the model, composed of triangles (mesh), could show the facets
instead of soft surfaces, rounded or well detailed. This depends on the number of mesh that compose the object. More triangles can bring more detail, or are
simply the result of a process of creating the mesh not optimized.
The number of mesh determs more work for the slicing software and if the triangles are tens of thousands, then they can even arise processing problems. As you can guess,
below a certain threshold the details are no longer "solved" by the printer, and then they are essentially useless. Or rather, are significant in view of a magnification of the
model for the printing of its detail. To reduce the number of triangles that describe the 3D model there are several programs and even the same Slic3r offers an option
that allows you ignore details under a defined size, simplifying and speeding up the slicing of the model
Finally it should be considered that the minimum thickness recommended of the vertical walls is 1.44 mm which consists of three perimeters made by the extruder. Walls
of a lower thickness are printable, but are fragile and composed only by the perimeter, without internal filling.
Clips position
Please note that the two clips blocking the printing glass invade the printing area; but their position is fixed, so you can print objects that have a
maximum size up to 250 mm in all the area, except where the clips are.
10 - Ordinary maintenance
Taking care of the printer
Sharebot XXL+ does not require special maintenance operations, but like all machines, increases efficiency if kept clean.
Sharebot srl
Nibionno Italy
All rights reserved
. No part of this manual
may be reproduced or transmitted in any form or by any means without prior permission
page 37