Sharebot Next Generation XXL+
user's manual
The support material are vertical structures generated -in this case – under the surfaces tilted over 45°.
Need to consider that in the model surfaces in contact with the support material e will have a coarser surface finish, for the real possibility that the two areas are fused
together: this would need a post-processing of the printed part to remove the support material from it and some finishes (if necessary). In any case, the same tilted surface,
will always have a lower finish if is negatively tilted (overhang) in comparison with the same positively oriented.
Details in prints
When printing a piece, is defined between the various parameters even layer thickness. This value has a significant impact in the object definition especially for all
surfaces that grow upward (Z) with a very bland inclination. Imagine an inclined plane and mentally sliced: the size of the slices can vary widely and, if they are drawn with
a fixed width line, you can see open spaces between layers. If the number of slices increases because they are thinner, the space between an edge of the layer and the
next is reduced, therefore, the shape is better defined both under the horizontal profile, both vertical. For this reason also the resolution of the Z axis is advertised as a
distinctive element of 3D printers.
A collateral effect of the prints with very low thicknesses of the layers (0.1 or 0.2 mm) is the increase in printing time: the part will be built with the same amount of
Sharebot srl
Nibionno Italy
All rights reserved
. No part of this manual
may be reproduced or transmitted in any form or by any means without prior permission
page 36