Sharebot Next Generation XXL+
user's manual
Positioning the printer
For proper operation, the printer must work in a clean and dust-free space, with an ambient temperature between 10° C and 30° c. It is also preferable a position away
from drafts or air conditioning.
In the left back you’ll find power switch so we recommend to leave it easily accessible; the power cable is the only way of separation of the plug from the mains. A t the
front -bottom left – and on the left side of the printer, you will find the ventilation of the electronic parts from wich depends the correct circuit cooling: these must be left
unobstructed
.
Remember that the filament is usually in a spool and that this should be positioned on the reel-carrier included in the packaging Remember that the wire is usually in a
spool and that this should be positioned on the reel-carrier included in the packaging . The recommended position is behind the printer, on the same floor, unrolling the
filament bottom up. There are alternative positions that possibles, but in that case you have to disable the filament presence from the “prepare” menu. The important thing
is that the filament flow and is dragged smoothly without whatsoever impediment throughout all the print area useful. For this reasons, the printer may not be placed in
places that haven't at least 35 cm free space around the rear or side.
Assembling the spool-holder
Using the screwed bar and the nuts, assemble the spool-holder. Do not overtighten the screws to avoid
breaking the plexiglass. Orientate the sides with the hole for the threaded bar facing up and logos readable
from the outside.
To insert the filament spool, remove one side of the spool-holder and the relative nut.
Place the spool-holder behind the printer remembering that the filament must flow rectilinearly, smoothly and
without obstacles.
Sharebot srl
Nibionno Italy
All rights reserved
. No part of this manual
may be reproduced or transmitted in any form or by any means without prior permission
page 12