SGM Pilot 2000, Быстрая инструкция, Страница: 22 / 32

PILOT 2000 USER GUIDE
To set the Hard/Soft Cross:
1. Scroll with the up/down arrows until “Hard/Soft Cross” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here each channel as Soft or Hard. Soft allows to
change the status, of a single parameter, to time. Hard mode, allow the snap
changing, of the status of a single parameter, at the fastest speed available when
running into a sequence
4. Press the left-hand Scroll button to escape the menu.
To set the Reset/Lamp value:
1. Scroll with the up/down arrows until “Reset/Lamp value” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set the channel for the remote reset and remote lamp
ON/OFF and the On/Off values which enable the parameters to act.
4. Press the left-hand Scroll button to escape the menu.
To set the Dip-switch configuration:
1. Scroll with the up/down arrows until “Dip-switch configuration” appears on the
display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here the quantity of dip-switches the fixture uses to
assign the start address. SGM’s fixtures use 9 switch dip-switches.
4. Press the left-hand Scroll button to escape the menu.
To set the Beam find value:
1. Scroll with the up/down arrows until “Beam Find Value” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here the open position to those channels
parameters which allows the operator to see the fixture’s beam when setting the
Working Area (iris open; dimmer open; strobe open; white open to gobo and color)
4. Press the left-hand Scroll button to escape the menu.
To set the Control Type for each parameter:
1. Scroll with the up/down arrows until “Control Type” appears on the display.
2. Press the right-hand Scroll button to enter the menu.
3. By using the up/down arrow, set here the control type for the fixture’s channels. The
control type can be Linear (Lin) or Tabled (Tab) .
4. Lin channels use all the DMX range of values to control a fixture’s function while
Tab channels use only the DMX values, which select a specific Gobo or Color.
5. Press the left-hand Scroll button to escape the menu.
22
SGM A/S · Ver. 2.03