PILOT 2000 USER GUIDE
To edit a Program:
1.Select a
Memory
2.Press
Program
key
3.Press a button 1-20 (21-40) of the MFK according to the program to be created
4.Press
Edit
Key
5.Press
right arrow
of the scroll buttons (located on the right of the display)
6.Select
Edit Step
from the edit menu
7.Press
right arrow
of the scroll buttons
8.Rise the fader below the display to set the desired value for each fixture’s channel or
assign a shape
9.Press and hold down the
Store
key
10.At the same time push the MFK button corresponding to the step to be stored
11.Repeat from the above item 7 till the last step is programmed
12.Push the
left arrow
until the display shows the program number and the Length of
the steps
13.Press
Edit
button
14.Press
Enter
button
15.Now your program is stored
To set the Active Effects of a Unit:
The Active Effects are the control channels of a Unit. By the time, enable or disable those
control channels could be helpful especially when mixing several programs (maximum 4 at
once), which contain the same fixtures. A color chase program (which has only the control
channel color enabled) can be mixed with another program which makes only the mirror
movement (that means Pan & Tilt enabled while the other control channels are all
disabled).
On the other hand, if the above 2 programs were made with all the control channels
enabled, only one program per time could be used.
The default settings are with all the control channels enabled.
1. Press
Edit
Key
2. Press
right arrow
of scroll buttons
3. Select
Active Effects
from the
Edit Menu
4. Press
right arrow
5. Push the buttons of the scan section according to the requirements. The buttons’ LED
show the status of the channel:
LED lit
means channel enabled;
LED not lit
means
channel disabled.
6. Press
left arrow
to escape the menu and store the settings
7. Push Up/Down arrow to select the
Edit Step Menu
and start programming.
SGM A/S · Ver. 2.03
15